EN
Ultrix 600mm
10
Disassembly
CAUTION:
DO NOT handle the motor while the flight
battery is connected. Personal injury could result.
1. The motor covers are secured to the wing using clear tape.
2. Disconnect the motor connector from the receiver.
3. Cut the tape and decals on the fuselage and carefully
remove the motor covers.
4. Remove the 2 screws from the motor mount to
remove the motor mount and motor from the wing.
5. Remove the 4 screws from the back of the motor to
remove it from the mount.
6. The propeller requires a 1.5mm hex driver to remove
the 2 screws holding the propeller on.
Assembly
Assemble in reverse order, connecting the motor covers to
the wing with clear tape.
A
A
A
A
G
G
A
A
A
E
A
C
E
A
D
B
A
A
F
F
Front View
Propeller direction
1 Disconnect the flight battery from the ESC.
2 Power OFF the transmitter.
3 Remove the flight battery from the aircraft.
4 Recharge the flight battery.
5 Repair or replace all damaged parts.
6 Store the flight battery apart from the aircraft and
monitor the battery charge.
7 Make note of the flight conditions and flight plan
results, planning for future flights.
Post Flight Checklist
Service of Power Components
Replacement Parts List
Part #
Description
A EFL02201
Replacement Airframe: Ultrix 600mm
B EFL02202
Vertical Fin Set: Ultrix 600mm
C EFL02203
Pushrod/Nosewheel: Ultrix 600mm
D EFL02204
Battery Hatch: Ultrix 600mm
E SPMA3255
RX/ESC Unit: Ultrix 600mm
F SPMSH2040LW 2.9g Linear Long Throw Servo
G SPMXAM2000
1206-3900Kv Motor: Ultrix 600mm
H EFLP9448
Prop Set (4): Ultrix 600mm
