EN
5
Using Bind Button
Using Bind Plug
SAFE Select Enabled
SAFE Select Enabled:
The control surfaces cycle back and forth
twice
with
a slight pause at neutral position every time the receiver is powered on.
Press and hold Bind
Button
Connect Power
Lower Throttle
Release Bind Button
Orange Flashing LED
Bind TX to RX
SAFE Select Enabled
SAFE Select Enabled:
The control surfaces cycle back and forth
twice
with a
slight pause at neutral position every time the receiver is powered on.
Install Bind Plug
Remove Bind Plug
Lower Throttle
Connect Power
Bind TX to RX
Orange Flashing LED
BIND
BIND
SAFE Select Disabled
SAFE Select Disabled:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
Press Bind Button
Lower Throttle
Connect Power
Bind TX to RX
Release Bind Button
Orange Flashing LED
SAFE Select Disabled:
The control surfaces cycle back and forth
once
every time the receiver is powered on.
SAFE Select Disabled
Install Bind Plug
Connect Power
Lower Throttle
Remove Bind Plug
Bind TX to RX
Orange Flashing LED
BIND
BIND
Transmitter and REceiver Binding / Switching ON and OFF SAFE Select
SAFE Select Technology, Optional Flight Envelope Protection
The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight protection. SAFE mode includes angle limits
and automatic self leveling. AS3X mode provides the pilot with a direct response to the control sticks. SAFE Select is enabled or disabled during the bind process.
With SAFE Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the aircraft will be in SAFE Select mode all the time, or you can assign a
switch to toggle between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or mode selection can be assigned to a switch.
IMPORTANT:
Before binding, read the transmitter setup section in this manual and complete the transmitter setup table to ensure your transmitter is properly
programmed for this aircraft.
IMPORTANT:
Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral. Move the throttle to low before and during
binding. This process defines the failsafe settings.
You can use either the
bind button
on the receiver case
OR
a conventional
bind plug
to complete the binding and SAFE Select process.
General Binding Tips
• The included receiver has been specifically programmed for operation of
this aircraft. Refer to the receiver manual for correct setup if the receiver is
replaced.
• Keep away from large metal objects while binding.
• Do not point the transmitter’s antenna directly at the receiver while binding.
• The orange LED on the receiver will flash rapidly when the receiver enters
bind mode.
• Once bound, the receiver will retain its bind settings for that transmitter
until you re-bind.
• If the receiver loses transmitter communication, the failsafe will activate.
Failsafe moves the throttle channel to low throttle. Pitch and roll channels
move to actively stabilize the aircraft in a descending turn.
• If problems occur, refer to the troubleshooting guide or if needed, contact
the appropriate Horizon Product Support office.