EN
11
The recommended receiver for this aircraft is the Spektrum AR637T. If you
choose to install a different receiver, ensure that it is at least a 6-channel
full range receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR637T Installation
1. Before installing the bottom wing, position the aircraft so the bottom of the
fuselage faces up. If the bottom wing has already been installed, remove
the bottom wing to expose the receiver compartment.
2. Connect the appropriate control surfaces to the their respective ports on
the receiver using the table at the right.
3. Using double-sided servo tape,(not included) mount the receiver to the flat
area behind the battery compartment, as shown. The receiver (
A
) should
be mounted in the orientation shown, parallel to the length of the fuselage,
with the label visible and the servo ports facing the rear of the aircraft. The
orientation of the receiver is critical for all AS3X
®
and SAFE
®
technology
setups.
CAUTION:
Incorrect installation of the receiver could cause a crash.
PNP Receiver Selection and Installation
A
AR637T Port
Assignments
BND/PRG = BIND
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
5 = Open
6 = Open
Model Assembly
Continued
Propeller and Spinner installation
1. Slide the collet (
A
), backplate (
B
), spinner backplate (
C
) and the propeller
(
D
) on the motor shaft. Ensure the propeller size (11 X 6.6) faces forward.
2. Slide the washer (
E
) on the propeller shaft and tighten the spinner nut (
F
)
with an adjustable wrench to secure the propeller into place.
3. Slide the spinner (
G
) on the propeller shaft in front of the propeller.
4. Secure the spinner with the spinner screw 3 x 8mm (
H
).
Disassemble in reverse order.
NOTICE:
Ensure the propeller is secure using an adjustable wrench before
securing the spinner
Motor Shaft Diameter: 5mm
Collet thread size: 6mm
A
B
C
D
E
F
G
H