11
EN
• In
Stability Mode
(FM0), the bank angle is limited. When the
sticks are released, the quadcopter will return to level fl ight.
If the camera is not installed on the quadcopter, the
continuous fl ip feature is available in Stability Mode.
To use the continuous fl ip feature, hold the continuous fl ip
button/switch and move the cyclic stick in any direction.
The quadcopter will begin fl ipping in the chosen direc-
tion when the cyclic stick is moved beyond 85% travel.
Release the fl ip button/switch to stop the rotation. Given
enough altitude, the quadcopter will self level and the
bank angle limits will be active.
If the cyclic stick is held after releasing the fl ip button, the
quadcopter will return to upright fl ight in the direction chosen.
NOTICE:
When using the continuous fl ip feature, always
allow the quadcopter enough altitude to recover.
• In
Stagility Mode
(FM1), the bank angle is limited up
until 85% stick travel. Beyond 85% stick travel, the bank
angle is unlimited to allow for more advanced aerobatics.
If the sticks are released, the quadcopter will return to
level fl ight.
• In
Agility Mode
(FM2), the quadcopter has no bank angle
limits, and will not return to level fl ight if the sticks are
released. Use rates and expo to tune the performance
according to your fl ying style.
Refer to the
Transmitter Setup Table
for transmitter switch
selection and specifi c setup information.
Flight Mode Selection
Camera Controls
Consult your local laws and ordinances before choosing a
location to fl y your aircraft.
We recommend fl ying your aircraft outside in calm winds
or inside a large gymnasium. Always avoid fl ying near
houses, trees, wires and buildings. You should also be care-
ful to avoid fl ying in areas where there are many people,
such as busy parks, schoolyards or soccer fi elds.
Takeoff
Select Stability Mode (FM0). Slowly increase the throttle
until the motors start and the quadcopter begins to lift off.
Continue raising the throttle until the quadcopter is ap-
proximately 2 ft. (600mm) off the ground. Adjust the trims
so the model fl ies as desired. Once the trims are adjusted,
begin fl ying the model.
Flying the Zeyrok
™
Quadcopter
Insert a micro SD card into the slot in the quadcopter until
it locks. Make sure the metal contact is facing up and the
notch in the card is facing forward as in the illustration.
Tweezers or small pliars may be necessary to install and
remove the micro SD card.
Power on the transmitter and quadcopter normally.
MLP6 RTF Transmitter users:
To take a still photo, quickly pull and release the camera
control switch twice. The rear LEDs on the quadcopter
will blink once as the camera takes the photo.
To start/stop recording video, pull and hold the camera
control switch for approximately 3 seconds. The rear
LEDs will begin fl ashing slowly, indicating the camera is
recording video. To stop the recording, pull and hold the
camera control switch for 3 seconds. The rear LEDs will
glow solid once again.
BNF Transmitter users:
Follow the instructions for your transmitter in the
Transmitter Setup
section to control the camera.
To retrieve the video and photos from the camera:
Press the micro SD card in and release it to unlock. Pull
the card out from the quadcopter. Insert the card in the
micro to SD card adapter. The micro SD card can now be
read by any SD capable device.
3. Attach the camera control board to the landing gear
using 3 screws.
4. Connect the camera control cable to the quadcopter. The
black, negative terminal should go toward the rear of the
quadcopter. Attach the landing gear to the quadcopter
using 4 screws.