12
EN
Entering Gain Adjustment Mode
DX6, DX6e and DX6i Users:
1. Lower the throttle stick to the lowest position.
2. Power ON the transmitter.
3. Install the fl ight battery on the helicopter frame, secur-
ing it with the hook and loop strap.
4. Connect the battery connector to the ESC.
5. Before initialization is complete, move and hold both
transmitter sticks to the bottom right corner as shown.
6. When the servos move, you have entered Gain Adjust-
ment Mode.
7. Release the sticks and proceed to Adjusting the Gain
Values to make any desired changes.
DX7s, DX7 (G2), DX8, DX8 (G2), DX9, DX18 and DX20 Users:
1. Lower the throttle stick to the lowest position.
2. Power ON the transmitter.
3. Install the fl ight battery on the helicopter frame, secur-
ing it with the hook and loop strap.
4. Connect the battery connector to the ESC.
5. Place the helicopter on a fl at surface and leave it still
until the orange receiver LED glows solid, indicating
initialization is complete.
6. Move and hold both transmitter sticks to the bottom
right corner as shown.
7. Press and hold the bind/panic switch until the swash
servos move.
8. Release the sticks and the bind/panic switch. The
model is now in Gain Adjustment Mode.
9. Proceed to Adjusting the Gain Values to make any
desired changes.
Adjusting the Gain Values
If you are using a Spektrum™ telemetry-enabled transmit-
ter, the gain adjustments can be viewed on the Flight Log
screen. Refer to your transmitter instructions to locate this
screen. The gain parameter currently selected will fl ash
on the transmitter screen. If you are not using a Spektrum
telemetry-enabled transmitter, the parameter and gain
values are indicated by the position of the swashplate on
the helicopter.
Once you have entered Gain Adjustment Mode, you can
move the cyclic stick right and left to select the gain pa-
rameter you would like to adjust. Moving the stick right will
select the next parameter. Moving the stick left will select
the previous parameter.
The selected gain parameter is indicated on the Flight Log
screen and by the lean of the swashplate on the roll axis.
Parameter #
Display
location
Swash Position
Page #
1
A
100% to the Left
1
2
B
50% to the Left
1
3
L
25% to the Left
1
4
R
Swashplate Level
1
5
A
25% to the Right
2
6
B
50% to the Right
2
7
L
100% to the Right
2
P age number
1 = Cyclic gains
2 = Tail rotor gains
Gain parameter
selected
Gain value
display location
Flight Log Screen
