Horizon Hobby Blade 150 FX RTF, Инструкция по эксплуатации

Страница: 10 / 15

10
EN
Part # Description
BLH4400 Blade 150 FX
1 BLH4401 Flight Controller: 150 FX
2 BLH4402 Main Motor: 150 FX
3 BLH4403 Taily Assembly w/Motor: 150 FX
4 BLH4404 Main Rotor Hub and Shaft: 150 FX
5 BLH4405 Main Grip (2): 150 FX
6 BLH4406 Swashplate and Linkage Set: 150
7 BLH4407 Main Frame: 150 FX
Part # Description
8 BLH4408 Main Gear Assembly: 150 FX
9 BLH4409 Replacement Servo: 150 FX
10 BLH4410 Main Rotor Blades (2): 150 FX
11 BLH4411 Replacement Fuselage: 150 FX
12 BLH4412 Screw Set: 150 FX
13 BLH4413 Tail Blades (2): 150 FX
14 BLH4414 Battery Mount: 150 FX
15 BLH4421 2S 320mAh LiPo: 150 FX
Problem Possible Cause Solution
Green LED on the aircraft
flashes rapidly then goes
off and the aircraft will not
respond to transmitter
(during binding)
Bind switch or button was not held
while transmitter was powered on
Power off transmitter and repeat bind process
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another location
and attempt binding again
LED on the flight control
board flashes rapidly and the
helicopter will not respond to
the transmitter
(after binding)
Less than a 5-second wait between first
powering on the transmitter and connecting
the flight battery to the helicopter
Leave the transmitter powered on. Disconnect and
reconnect the flight battery to the helicopter
Flight battery or transmitter battery
charge is too low
Replace or recharge batteries
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another location
and attempt binding again
Helicopter vibrates or shakes
in flight
Damaged rotor blades, spindle or blade
grips
Check main rotor blades and blade grips for cracks or chips.
Replace damaged parts. Replace bent spindle
Random movements in flight Vibration
Verify the receiver is properly attached to the helicopter. Inspect and
balance all rotating components. Verify the main shaft and tail rotor
are not damaged or bent. Inspect mechanics for broken or dam-
aged parts and replace as necessary
Tail oscillation/wag or poor
performance
Damaged tail rotor, tailboom, main gear
mesh, main shaft, loose bolts, vibration
Inspect the tail rotor for damage. Inspect the tail boom for cracks.
Verify main gear mesh and ensure no tight spots in the mesh through
full rotation. Replace any damaged or worn components
Drift in wind Normal
The model will drift with the wind but should remain level in flight.
Simply hold the cyclic stick in the necessary position to keep the model
stationary. The model must lean into the wind to remain stationary. If
the model remains level then it will drift with the wind
Model does not return to level
when the sticks are centered
Model was not initialized on a level
surface
Re-initialize the model on a level surface
Model was not taken off of a level surface Always lift off from a level surface
Severe vibration
Main shaft is bent Check the main shaft for damage and replace if necessary
Rotating component out of balance
Check the main shaft, tail rotor, main rotor blades and main frame for
damage and replace as necessary
Parts Listings