8
EN
Power
INSTALL THE VEHICLE BATTERY
The following steps show the installation of a standard size battery in the rear battery tray of the vehicle. If you wish to use a “shorty” style
battery, it should be installed in the side battery tray location.
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter.
Failsafe:
Hold the steering wheel and throttle trigger in the desired
failsafe positions during binding
1. Press and hold the bind button.
2. Power ON the receiver. The orange LED will begin to flash.
3. Set the trims and control positions at the desired failsafe settings.
4. Power ON the SLT3 transmitter.
5. When the transmitter’s orange LED remains lit, it is connected to
SR315 receiver.
You must rebind when:
• Different failsafe positions are desired (e.g., when throttle or steering
reversing has changed).
• Binding the receiver to a different transmitter.
Bind Button
BINDING
2. Remove the four body clips from the body.
3. Lift the body from the chassis.
4. Place the battery in the battery tray. The battery tray length may be
adjusted to fit the battery as described in the previous section.
5. Secure the battery to the tray with the hook and loop strap.
6. Connect the battery to the ESC.
7. Re-install the body and four body clips to the chassis.
NOTICE:
Always disconnect the battery from the ESC before
powering off the transmitter. Loss of vehicle control may result.
1. Power on the transmitter.
www.modellmarkt24.ch
