6
EN
INSTALL THE TRANSMITTER BATTERIES
TRANSMITTER FUNCTIONS
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION:
NEVER remove the transmitter batteries while the
model is powered on. Loss of model control, damage, or injury
may occur.
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/or
damage to property.
CAUTION:
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.
Follow the manufacturer’s directions for your charger to properly
charge the vehicle battery.
CAUTION:
Only use chargers designed to charge the chosen
battery type. Using an incorrect charger or incorrect charger
settings could cause the battery to catch fire or explode.
CHARGE THE VEHICLE BATTERY
A. Throttle Trim
Adjusts the throttle neutral point
B. Steering Trim
Adjusts the steering center point. Normally, the steering trim is
adjusted until the vehicle tracks straight.
C. LED
• Solid red lights: Indicates the power is ON and adequate battery
power
• Flashing red lights: Indicates the battery voltage is critically low.
Replace batteries
D. Steering Wheel
E. Throttle/Brake
F. Steering Rate
On-The-Fly knob for travel adjustment on the steering
G. Channel 3
3 position momentary switch, middle position is neutral
For programming press up for A button, press down for B button
H. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are
driving the vehicle in a small area.
I. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
J. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
K. Power Button
A
B
C
D
E
F
G
H
I
J
K
SPECIFICATIONS
Power Supply:
4 AA Batteries
Operating Frequency:
2.4GHz
Transmit Power:
<100mw
Control Protocol:
SLT
Control:
Proportional Steering and Throttle/Brake with Trim Knobs,
Third Channel with 3 Position Momentary Switch
Auxiliary Functions:
3 Position Throttle Limit Switch, Steering Rate
Knob to Change Steering Travel on-the-fly, Programmable Servo Travel
for Steering and Throttle/Brake
www.modellmarkt24.ch
