EN
4
WET CONDITIONS MAINTENANCE
• Drain any water that has collected in the tires by spinning them at high speed. With the body removed, place the
vehicle upside down and pull full throttle for a few short bursts until the water has been removed.
CAUTION:
Always keep hands, fingers, tools and any loose or hanging objects away from rotating parts
when performing the above drying technique.
• Remove the battery pack(s) and dry the contacts. If you have an air compressor or a can of compressed air, blow out
any water that may be inside the recessed connector housing.
• Remove the tires/wheels from the vehicle and gently rinse the mud and dirt off with a garden hose. Avoid rinsing the
bearings and transmission.
NOTICE:
Never use a pressure washer to clean your vehicle.
• Use an air compressor or a can of compressed air to dry the vehicle and help remove any water that may have gotten
into small crevices or corners.
• Spray the bearings, drive train, fasteners and other metal parts with a water-displacing light oil. Do not spray the motor.
• Let the vehicle air dry before you store it. Water (and oil) may continue to drip for a few hours.
• Increase the frequency of disassembly, inspection and lubrication of the following:
• Front and rear axle hub assembly bearings.
• All transmission cases, gears and differentials.
• Motor—clean with an aerosol motor cleaner and re-oil the bushings with lightweight motor oil.
BOX CONTENTS
SPECIFICATIONS
Length
8.6” (220mm)
Width
3.9” (100mm)
Height
3.6” (93mm)
Operating Weight
8 oz (226.8g)
INCLUDED COMPONENTS
Vehicle
SCX 1967 Chevrolet C10 Truck 1/24th Scale RTR
(AXI00001)
Transmitter
AX-4 2.4 GHz 3 channel (AXI31618)
Charger
USB LiPo Charger (DYNC1063)
Vehicle Battery
7.4V, 350mAh, 2S LiPo (DYNB0012)
Motor
SCX24 030-Motor with Pinion (DYNS1217)
ESC/Receiver
AE-6 ESC/Rx with Forward and Reverse (AXI31620)
Servo
AS-1 Micro Servo (AXI31619)
Transmitter Batteries
(4) AA Alkaline