Alpha Patrol Boat
Boat Stand Assembly
1.
Attach the side stand pieces to the end pieces as
shown.
2.
Use medium CA or epoxy adhesive to secure the side
stand to the ends.
3.
Allow the adhesive to dry before placing your boat on
the stand.
1. Bow Hatch:
Carefully lift the bridge canopy and bridge
assembly to access the receiver.
2. Middle Hatch:
Carefully lift the machine gun base
to access the battery compartment, steering servo,
motors, and ESC. The cover magnetically attaches to
the hull.
NOTICE:
Do not lift the cover by pulling on the
machine guns or you may damage the guns.
3. Rear Hatch:
Use a 2mm hex driver to remove the
6 screws from the cover (located at the transom) to
access the motor and motor couplers. Carefully lift the
cover using the 2 fuel drums attached to it.
NOTICE:
If the cover does not easily come apart
from the boat, use the hatch under the machine gun
base to push up on the cover to free it from the hull.
Applying too much upward force on the barrels can
break them loose from the cover.
Hatch Removal
4
EN
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Phillips screwdriver: #1
Recommended Tools and Materials
2.4GHZ DIGITAL
RADIO SYSTEM
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm
• Clear tape (DYNM0102)
• Pro Boat
®
Marine Grease and Gun
• Hook and Loop Tape Set, WP 4pcs
