Horizon Fitness SPF-10II, Руководство пользователя

Страница: 34 / 50

30
3. Preparing and Adjusting the Stitching Head
3-1 Threading Wire
WARNING
Be sure to turn power off whenever
setting stitcher head.
(1) Draw wire from the bottom of wire coil
with pliers, and thread wire through slot at
the end of wire guide spring, through wire
guides, through upper wire straightener and
between tension pawl and tension roll.
NOTE
Make sure that wire is loaded on coil holder
stud so that wire feeds counterclockwise from
the bottom of coil.
(2) Adjust resister plate pressure by applying
or releasing pressure on resister plate
according to remaining quantity of wire.
NOTE:
- If friction is too loose, coil will continue to
rotate after machine stop. This causes wire
to tangle.
- If friction is too tight, full length of wire
will not be fed for each stitch. This causes
variation in leg length.
(3) Adjust upper wire straightener so that wire
is parallel with face plate. And then adjust
lower wire straightener so that wire feeds
to the right of face plate.
Wire Guide Friction
Upper Wire
Straightener
Lower Wire
Straightener
Face Plate
Wire
Wire
Guide Friction
Coil Reel
Wire Guide
Spring
Stud
Parallel