BEFORE
YOU
BEGIN
8
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
A
Open
HARDWARE BAG 1.
B
Connect
CONSOLE WIRES
.
C
Slide
CONSOLE MASTS
over
BASE
FRAME BRACKETS
.
D
Insert
BOLT (A)
and
FLAT WASHER
(B)
into bottom side hole and
attach with
NUT (C)
.
E
Insert
BOLT (D)
and
FLAT WASHER
(B)
into rear hole.
F
Repeat on other side.
G
Insert
BOLT (D)
and
FLAT WASHER
(B)
into top side hole.
H
Insert
BOLT (D)
into rear-most
inside hole.
I
Repeat on other side.
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
PRE-ASSEMBLY
�������������
������������������
ASSEMBLY
STEP 1
���������������
������
��������
�����
������
��������
�����
������
�������
�����
������
HARDWARE BAG 1 CONTENTS :
�������
��������
����������������
��������
��������
��������
���������������
Steps A-C
Steps D-F
Steps G-I
A
Open
HARDWARE BAG 2.
B
Slide
CONSOLE MAST BOOTS
down over
BASE FRAME
.
C
Lift
RUNNING DECK
to upright
position.
D
Insert 4
SCREWS (E)
into inside
holes of
CONSOLE MAST BOOTS
.
E
Connect
CONSOLE WIRES
.
F
Slide
CONSOLE BRACKETS
into
CONSOLE MAST
as shown.
G
To attach
CONSOLE
, insert
1
FLAT WASHER (F)
, 1
LOCK
WASHER (G)
and 1
BOLT (D)
into
all 6 holes on upper
CONSOLE
MASTS
.
ASSEMBLY
STEP 2
�����������������
������������
����������
������������
����������
����������������
������������
���������
����������������
����������������
�������������
���������������
�����
������
���������������
�����
������
��������
�����
������
���������
�����
������
HARDWARE BAG 2 CONTENTS :
PST6-PST8 Treadmill Rev 1.6.indd 8-9
7/25/05 1:49:41 PM
