8
9
BOLT (K)
20 mm
Qty: 2
SPRING WASHER (L)
15 mm
Qty: 2
RUBBER WASHER (O)
26 mm
Qty: 2
FLAT WASHER (N)
25 mm
Qty: 4
FLAT WASHER (M)
20 mm
Qty: 4
BOLT (G)
20 mm
Qty: 2
SPRING WASHER (H)
15 mm
Qty: 2
FLAT WASHER (I)
20 mm
Qty: 2
WAVY WASHER (J)
22 mm
Qty: 2
ASSEMBLY
STEP 3
A
Open
HARDWARE FOR STEP 3
.
B
Carefully pull the
CONSOLE CABLE
through
the
CONSOLE MAST
using the twist tie located
inside the
CONSOLE MAST
.
C
Attach the
CONSOLE MAST
to the
MAIN
FRAME
using 4
PRE-INSTALLED BOLTS
and 4
PRE-INSTALLED WASHERS
.
d
Slide 1
WAVY WASHER (J)
over
CRANK
followed by
PEDAL ARM
as shown. Rest
PEDAL
ARM WHEEL
on
GUIDE RAIL SET
.
E
Attach
PEDAL ARM to CRANK
using 1
BOLT
(G)
, 1
SPRING WASHER (H)
and 1
FLAT
WASHER (I)
.
F
Repeat steps d-E on the opposite side.
ASSEMBLY
STEP 4
A
Open
HARDWARE FOR STEP 4
.
B
Slide 1
RUBBER WASHER (O)
and 1
FLAT
WASHER (N)
onto
CONSOLE MAST
.
C
Slide
LOWER HANDLEBAR
onto
CONSOLE
MAST
and attach using 1
FLAT WASHER (N)
,
1
FLAT WASHER (M)
, 1
HANDLEBAR CAP
, 1
FLAT WASHER (M)
, 1
SPRING WASHER (L)
and 1
BOLT (K)
.
d
Repeat steps B-C on the opposite side.
HARDWARE foR STEP 4
:
HARDWARE foR STEP 3
:
PRE-INSTALLED BOLTS
PRE-INSTALLED WASHERS
BOLT(G)
SPRING WASHER(H)
FLAT WASHER(I)
WAVY WASHER(J)
CONSOLE CABLES
CONSOLE MAST
MAIN FRAME
CRANK
PEDAL ARM
PEDAL ARM WHEEL
GUIDE RAIL SET
BOLT(K)
SPRING WASHER(L)
FLAT WASHER(M)
HANDLEBAR CAP
LOWER HANDLEBAR
FLAT WASHER(N)
RUBBER WASHER(O)
CONSOLE MAST
NOTE: Be careful not to pinch any wires
while attaching the console
mast.
