12
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
&
MAINTENANCE
LIMITED
W
ARRANTY
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY
STEP
FLAT WASHER (J)
Qty: 8
NYLON NUT (K)
Qty: 4
BUMPER
Qty: 2
BOLT (I)
Qty: 4
HARDWARE BAG CONTENTS :
Open
HARDWARE BAG
.
Remove nylon nut and threaded
screw from end of
CABLE A
.
Insert cable end into
LAT BAR
ASSEMBLY BRACKET
pulley as
shown in diagram.
NOTE:
After passing through
second pulley bracket,
DUAL
FLOATING PULLEY BRACKET
must be installed.
Re-install threaded screw and
nylon nut before threading
cable into
TOP WEIGHT PLATE
.
NOTE:
Always maintain at least
½˝ of weight cable screw in
TOP WEIGHT PLATE
for saftey.
Hook
LAT BAR
on to cable using
the
HOOK
and rest in craddle.
A
B
C
D
E
ASSEMBLY
STEP
CABLE A
Qty: 1
HARDWARE BAG CONTENTS :
CABLE A
LAT BAR
RUBBER STOP
BALL
NYLON NUT (C)
FLAT WASHER (B)
DUAL FLOATING
PULLEY BRACKET
LAT BAR / WEIGHT
CABLE SCREW AND NUT
TOP WEIGHT
THREAD
HOOK
CLEVIS
FLAT WASHER (B)
SCREW (E)
Open
HARDWARE BAG
.
Insert each
GUIDE ROD
into the
BASE FRAME
as shown in diagram.
NOTE:
Ensure that holes in
GUIDE RODS
are located at the top.
Install rubber
BUMPER
onto each
GUIDE ROD
.
Install each
WEIGHT PLATE
onto
GUIDE RODS
NOTE
: Ensure that each
WEIGHT PLATE’
s selector pin slot faces downward.
Insert each
GUIDE ROD
into the corresponding hole in the
UPPER PULLEY ASSEMBLY
.
Secure
GUIDE RODS
in
UPPER PULLEY ASSEMBLY
using 2
BOLTS (I)
, 4
FLAT
WASHERS (j)
and 2
NYLON NUTS (K)
.
NOTE:
Ensure that each bolt is inserted through the hole at the top of the
GUIDE ROD
.
Install 2
BOLTS (I)
, 4
FLAT
WASHERS (j)
and 2
NYLON NUTS (K)
into the
BASE FRAME
as
shown in diagram.
Tighten all hardware.
A
B
C
D
E
F
G
H
BUMPER
GUIDE ROD
WEIGHT PLATE
TOP WEIGHT
BAYONET
SELECTOR PIN
NYLON NUT (K)
FLAT WASHER (J)
FLAT WASHER (J)
SCREW (I)
FLAT WASHER (J)
SCREW (I)
S400_US_1.1.indd 12-13
8/31/07 10:10:35 AM