horiba ABX MICROS ES60, Руководство пользователя

Страница: 120 / 200

ABX Micros ES60 OT/CT
5–22 User Manual - RAB237AEN
4.2. Calibration procedure
4.2.1. Startup cycle
◆
Run a startup cycle from the " Status area " before calibration creation.
The startup cycle must be successfully run before starting any calibration.
4.2.2. Repeatability check
◆
Before carrying out a calibration, it is essential to make sure that the instrument is in perfect
operating condition and to follow the steps bellow:
1- Carry out a concentrated cleaning procedure (See Section 7, 3.3.5. Concentrated cleaning, page
7-9 ).
2- Perform two blank cycles to check the cleanliness of the instrument.
3- Check the repeatability of the instrument by running a fresh normal whole blood sample 11 times
with no alarm. Discard the first result and calculate the CV on the remaining 10 runs.
4- Check that the CV calculated using the remaining 10 runs meets or exceeds the specifications:
See Section 2, Tab.2-10 Precision claims, page 2-10 .
5- Run a control blood and check that the values are within the acceptable limits. If not, run a new
control blood.
6- If the values are still out of the acceptable limits and the instrument is clean (blank cycles in
conformity with the values given in the manual) and repeatability is correct (acceptable CV values),
carry out the calibration (See
4.2.3. Running calibration, page 5-22 ).
4.2.3. Running calibration
Accessing the "Creation" screen
1- Press " Quality control menu " button ( Diag.5-1 ) to access the " Quality control " menu.
2- Press " Cal " tab.
3- Press " Calibration creation " button ( Diag.5-25 ).
◆
The " Creation " screen is displayed.
Diag.5-25 Calibration creation button
Diag.5-26 Calibrant creation screen