Operation Manual_MU_HPL_En
9
4.3 Refurbishment of the unit
The unit should be refurbished once a year or after 6,000 hours of unit operation,
whichever occurs earlier.
Refurbishment activities:
• tighten all bolts and nuts, and replace them if necessary;
• clean the entire system and the mating surfaces;
• check of the general technical condition of the unit;
• replace all idle rollers and fasteners (bolts), regardless of their condition;
• check the condition of the welded joints of all components of the conveyor system;
• check the correct operation of the unit;
• replace the fast wearing parts as listed below in section 8.
5
Occupational health and safety requirements
1. Before starting work, the operator must be properly trained and the particularly
dangerous areas must be pointed out to him or her.
2. Persons over 18 years of age may operate the unit, after appropriate training on
this type of equipment.
3. The operator should be thoroughly familiar with the operating regulations for
mechanical equipment, and should know and strictly follow the maintenance
instructions for the unit.
4. Operating the unit after consumption of alcohol is strictly prohibited.
5. Before starting work, check if the unit is ready for operation and that no danger to
personnel or other equipment, systems, etc. will occur when using the unit.
5.1 IT IS STRICTLY PROHIBITED TO:
1. Use the unit contrary to this manual;
2. Allow operation of the unit by unauthorized persons;
3. Make any repairs to the unit while it is in motion or with batteries loaded; and
4. Use a unit that is defective or not ready for operation.
5. ein defektes oder nicht betriebsbereites Gerät zu nutzen.
Содержание Xchange MU
Страница 12: ......
