- 7 -
user checklist
If your cleaner is not working properly run through the following checklist.
1 .Is there a working electricity supply to the cleaner? Check with another
electrical product.
2. Is the dust container full or choked with fine dust? To empty the dust container
sec the instructions on page 5/6.
3. Is the hose blocked? To clear a blockage, see the instructions on page 6.
4. Is there a blockage in the cleaner base? To clear a blockage, see the
instructions on page 6.
5. Are the filters blocked? To clear the fitters, see the instructions on page 5.
6. Are the brushes rotating correctly? To check the brushes, see the instructions
on page 6.
7. Has the cleaner overheated? If so, it will take about 45 minutes to reset itself.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in
Working order, has not been assembled in accordance with these instructions or
has been used incorrectly.
Warning!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
imporTanT:
Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
imporTanT informaTion
Hoover Service
Should you require service at any time, please contact your local Hoover Service
Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
uSE only HooVEr SparES
SparE parTS & ConSumaBlES
CodE
FILTERS KIT
U76 - 35601699
HOSE
D156 - 35601698
AGITATOR
y36 - 35601697
bELT
V37 - 35601700
PET HAIR & ALLERGEN REMOVER
J44 - 35601064
quality
Hoover’s factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
guaranTEE STaTEmEnT
The guarantee conditions for this appliance are as defined by our representative
in the country in which it is sold. Details regarding these conditions can be
obtained from the dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim under the terms of this
guarantee.
Subject to change without notice.
Содержание WR71WR01001
Страница 1: ...USER MANUAL...
