Cleaning final filter
The
final filter
assists in the filtration
process to return clean air to the room.
To remove this filter when it becomes
dirty, open the door on the side of the
cleaner.
Lift out filter (B) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on the
side of the cleaner. Make sure the green
colored side of filter faces outward.
Close door.
Should you want to replace this filter,
ask for
HOOVER part No. 40110004.
Do not operate cleaner without either
the secondary or final filter in place.
Cleaning secondary filter
Disconnect cleaner from electrical
outlet.
The
secondary filter (A)
, located behind
the grill in the bottom of bag compart-
ment, protects the motor from dirt parti-
cles.
If filter becomes dirty, pull off grill and lift
out filter.
Hand wash filter in cold water with mild
detergent, then air dr y.
Reposition dry filter and grill.
Should you want to replace this filter, ask
for
HOOVER
part No. 38765019.
Replacing bag door
Reposition bag door by placing tabs on
bottom of door into opening (C).
Press top of door to snap securely shut.
9
3 - 5
3 - 2
A
B
C
A
C
B
Removing and installing filter
b a g
Grasp filter bag collar (A) and pull collar
f rom tube (B).
Note: Do not clean out old filter bag and
reuse. Discard used filter bag.
Hold new filter bag as shown. Align open-
ing in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.
Secondary and final
filters
3 - 6
Reattaching filter door
The filter door is designed with a “break-
away“ feature which allows it to snap
free if it is pushed open too far.
To reattach, align hinges (C) of cover
with slots on sides of filter area.
Press door back into place.
Check agitator shield
Because your cleaner picks up so well,
we strongly recommend you check for
debris accumulation under the agitator
shield each time you clean the filters.
Removing debris under the shield will
help maintain your cleaner’s excellent
pick up and suction. Remove debris as
follows:
1. Disconnect cleaner from electrical
outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-10),
removing agitator (Fig. 3-11), and lifting
agitator shield (Fig. 3-13).
3. Remove any debris and replace
shield, agitator and bottom plate (Figs.
3-13 to 3-15).
3 - 3
3 - 4
