2-2
2-3
2-4
B
A
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
To turn cleaner on, push switch up.
To turn cleaner off, push switch down.
Plug cord into electrical outlet.
Turn cleaner on and, with handle in
upright position, pull back on handle
until front of cleaner is lifted off the car-
pet. This insures that the paper bag is
inflated.
The handle of your cleaner has three
positions;
upright
for storage and when
using cleaning tools;
operating
for gen-
eral operation on carpet and floors;
low
for reaching under low furniture. Step on
handle release lever to lower handle.
2-5
2-6
2-8
2-7
To move your cleaner from room to
room, put handle in upright position, tilt
cleaner back on rear wheels and push
forward.
The cleaner can also be moved by lifting
it as shown.
When it is necessary to raise and lower
the front of the cleaner (A) for various
carpet pile heights, slide the nozzle con-
trol (B) knob to the correct setting.
(1) (2)
(3)
(4)
For ease in sliding knob, the handle
should be in the upright position.
The front of the cleaner will not move
into the adjusted position until the
cleaner handle is lowered to the oper-
ating position.
For maximum cleaning performance the
following carpet height settings are recom-
mended.
Cleaner nozzle settings:
• Lowest setting
(1): for bare floors and
low pile, level loop, kitchen type carpet.
• Next setting
(2):for other types of carpet.
• Higher settings
(3-4): for very deep pile
carpet where easier pushing effort is
desired, while maintaining good deaning
performance.
Note:
If the cleaner is difficult to push, slide
the knob to the next higher setting.
8
Handle positions
Transporting cleaner
Carpet height adjust
