3-9
3-10
3-11
3-12
12
3. Remove recovery tank front panel (F)
by sliding it straight up.
4. Replace panel with converter (G).
Slide converter halfway down opening
until it is firmly in place.
5.
Before connecting tube (H) to
cleaner, make sure black tabs are
extended by pulling tan collar toward
tube.
Open door on hood labeled “Stair/
upholstery Cleaning Connection”. Press
round solution tube connector onto
round projection inside door.
Press con-
nector collar down firmly to ensure
that it is fully connected.
When the solution tube is connected
to the deep cleaner, the nozzle brush-
es will automatically be turned off and
will not rotate when the deep cleaner
is turned on even if the speed selec-
tor is in the HI or LO position.
6.
The tank lid replaces in a hinge-like
manner.
Position front of lid under tabs
(I) on front of tank. Rotate lid down onto
tank.
Make sure lid is secure on all sides
before cleaning.
For full suction, it is important that
the recovery tank lid is properly
secured before cleaning.
Reverse procedure to remove hose
and solution tube.
Raise deep cleaner handle to upright
position.
How to attach tool
All tools connect to the hose in the
same manner.
1. Attach tool to connector end of hose
by sliding it onto connector until the tab
(J) locks it securely.
Using your thumb,
push forward and
up
on the latch (K) to remove tool as
shown.
Follow the instructions on pages 13 and
14 for the appropriate cleaning task.
J
F
I
G
H
K
3-13
Before using the
powered hand tool
It may be necessary to remove air from
the system (“prime the pump”) so the
clean solution will flow to the tool. Follow
these steps:
1. Attach powered hand tool to hose
and turn the deep cleaner ON.
2. Put the tool on a hard surface or
against your hand to block off the suc-
tion.
3. Wait a few seconds (can take up to
15 seconds). Then squeeze the trigger
and begin cleaning.
Follow the instructions on pages 13 and
14 for the appropriate cleaning task.
