background image

Read “Before you begin cleaning”
instructions on page 9.

 Fill clean solution tank (upper tank)

with HOOVER Carpet/Upholstery

Detergent according to instructions for
Figs. 2-8 to 2-14.

2. 

Move speed selector to LO for gen-

tle cleaning or HI for normal cleaning.

3. Dry hands and plug cord into a 

prop-

erly grounded outlet.

Do not clean over floor electrical out-
lets.

4. To avoid walking on damp carpet,
start at the end of the room farthest from
the door or path to sink where tanks will

be emptied and filled.

Step on handle release pedal and lower
handle to operating position; turn deep
cleaner ON.

5. Squeeze trigger to release cleaning
solution and 

slowly 

push deep cleaner

forward (equals one wet stroke).

6. Continue to squeeze trigger and

slowly 

pull deep cleaner back toward

you (second wet stroke). Release trigger
and slowly push deep cleaner forward
over area just sprayed with solution (dry
stroke). Then 

slowly 

pull deep cleaner

back toward you without squeezing trig-
ger (dry stroke).

7. Overlap strokes by 1 inch to help pre-
vent streaking.
Keep nozzle flat on floor for both for-
ward and reverse strokes.

8. For heavily soiled areas, repeat steps
5-7. Avoid saturating carpet, as 
below.

9. For particularly soiled carpet or
spots, use the Clean 

 button

(see following section). Avoid saturatrng
carpet, as noted below.

Note: To avoid saturating carpet, do
not use more than 4 wet strokes over
one area. Always end with dry
strokes.

It is best to alternate wet and dry
strokes as described above.

For best cleaning results and to 

 

faster drying of carpet, end with more
dry strokes. (Continue using dry strokes
until little water is visible passing
through the recovery tank lid.)

Empty recovery tank when the motor
sound becomes higher pitched and

there is a loss in suction (see

“Automatic shut-off”, Fig. 2-6)

When finished cleaning, follow “After

cleaning” instructions on pages 

 

 

The Clean Surge’ button can be used to
dispense extra solution when cleaning
particularly soiled areas of carpet or spots

To use, press ‘Clean Surge’ button while
squeezing solution trigger. For normal

solution spray, release button and contin-
ue to squeeze solution trigger.

Your deep cleaner may also be used to

pick up 

small liquid spills (1 gallon or

less, never to exceed 

 inch in

depth) 

on carpet, upholstery, or bare

floors.

1. For best results, pick up spills imme-

diately by placing the stair/upholstery
nozzle just above the spill and suction
up any residue on top of the carpet.

2. If the spill remains, place either the
stair/ upholstery nozzle or floor nozzle

with brushes turned OFF in 

front of the

spill, pull the nozzle very slowly over the
spill initially with suction only
Repeat with spray and suction.

When picking up spills on bare floors,

use only the floor nozzle with the bare

floor attachment in place and speed
selector in the OFF position 

(this wil! help

prevent spreading the spill).

If a spot is left, the stair/upholstery 

 

IS

generally more effective for removing it.

Although no cleaning solution can com-

pletely remove all spots, they can be treat-
ed by following the instructions provided
by the manufacturer of the carpet, uphol-
stery, or bare floor surface being cleaned

Do not use the deep cleaner to pick up

flammable or combustible liquids or
chemicals.

When finished, follow “After 

instructions on page 9.

   

 

 

Disconnect deep cleaner from electri-
cal outlet.

To prevent possible leaking, remove

clean solution tank (Fig. 2-8) and recov-
ery tank (Fig. 2-15) before positioning
bare floor attachment.
Set tanks aside (do not set tank on furni-
ture).

1. With handle in upright position, tilt

cleaner back so that handle rests on the
floor.

10

2. With foam strip (A) (located under the

3. Push attachment against nozzle while

netting) in position as shown, place

rotating attachment downward until both

attachment on front of nozzle (B).

ends snap into place.

Make sure arrow on end of attachment

(Note: 

 force may be required to

points in the direction as shown.

rotate and snap attachment into place.)

Содержание SteamVac Widepath
















Отзывы: