7
Turn cap upside down to serve as a measuring cup.
Fill cap to
upper “carpet” fill line
(5 ounces)
with HOOVER
Carpet/Upholstery Detergent.
For bare floors:
Fill cap to
upper "carpet” fill line
(5 ounces) with HOOVER
Bare Floor Cleaner
TANK CAP
3 OUNCES
(upholstery)
5 OUNCES
(carpet)
For carpet and carpeted stairs:
Using cap, measure detergent following the chart below.
FILL LINE
If rubber ring on cap has displaced, replace it with uneven side
against cap ledge as shown.
Pour detergent into tank.
Fill tank to fill line (1 gallon)
with hot tap water.
To assure proper performance,
use only ‘Hoover’ cleaning
detergent .
LEDGE
RUBBER
RING
NOTE: Use only HOOVER detergents.
They are specially
formulated for use with your 'SteamVac' deep cleaner.
For upholstery:
Fill cap to
lower “upholstery” fill line
(3 ounces) with
HOOVER
Carpet/Upholstery Detergent.
Remove clear cover and wipe off screen with a damp cloth.
Snap cover back into position.
The tanks
The clean solution tank holds the cleaning solution that is to be
dispersed onto the surface to be cleaned.
How to fill
Disconnect deep cleaner from electrical outlet.
TANK
HANDLE
Place deep cleaner handle in the upright, locked position.
Carry tank to a sink.
Rotate tank cap counterclockwise and lift up to remove cap.
To remove tank, press down on handle and pull forward.
Clean solution tank (upper tank)
Brush indicator
To clean screen,
turn deep cleaner off and disconnect from
electrical outlet.
3. Brush indicator screen dirty.
The brush indicator will spin
when the deep cleaner is
turned on and the brushes
are rotating.
If the indicator does not spin
and the pattern is visible
when the deep cleaner is
turned on, the brushes are
not rotating.
1. Brush speed selector set on OFF. (See previous section.)
There are three reasons why the brushes may not be rotating:
2. Solution tube connected (page 12).
Do not use Bare Floor Cleaner on carpet or upholstery.
Continued
➜
SCREEN
Do not use any type of wax with your ‘SteamVac’ deep
cleaner.
Brush indicator - Filling solution tank