2-12
Select proper tool
A. Dusting brush
may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters, and registers.
B. Furniture nozzle
may be used for
upholstered furniture, draperies, mat-
tresses, clothing, automobile interiors,
and carpeted stairs.
C. Powered hand tool
may be used for
upholstered furniture, carpeted stairs
and hard-to-reach places.
D. Crevice wand
can be used in tight
spaces, corners and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs, and baseboards.
It can also be used for extra reach with
the dusting brush and/or extension
wand.
E. Wand
is used to give extra length to
your hose. Use it with any of the above
tools.
A
B
C
A
D
C
D
E
A
B
Cleaning tools
When using cleaning tools,
cleaner han-
dle should be in the upright position
to activate the automatic “brush roll
automatic shut off” and for conve-
nience in moving the cleaner from
one area to another.
Attach wand and tools
Attach tool or wand to the hose (A) by
pushing it firmly into hose.
Attach second wand or tool to wand (B)
by pushing it firmly onto the wand.
Twist wand or tool slightly to tighten or
loosen the connection.
How to clean tools
To clean the hose and the powered
hand tool, wipe off dirt with a cloth
dampened in a mild detergent. Rinse
with a damp cloth. Do not submerge
powered hand tool in water.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air dry
before using.
2-10
Turn cleaner OFF before disconnect-
ing and connecting hose to hose tube
(A).
To use hose, lift hose end as shown.
2-13
Extra reach hose
(available at additional cost if not
included with your cleaner)
Push Custom Control™ switch to OFF
position.
Align end of extra reach hose with pro-
jections (C) over slots (D) on end of
attached hose.
Slide hose into slots and twist hose to
lock it in place. (To detach hose, reverse
procedure.)
Attach wands or tools to the other end of
hose.
6
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
Low/Hard Surface:
for bare floors and all
types of carpet
Note:
If the cleaner is difficult to push, turn
knob to the next higher setting.
High Pile:
for very deep pile carpet where
easier pushing effort is desired, while
maintaining good cleaning performance.
2-8
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
2-9
2-11