19
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Instructions (Cont.)
Step-by-step guide to using the dryer
(a) Loading
Open the door and load the dryer following the guidelines on page 15. The total
weight of the load to be dried depends on the program chosen. All maximum load
values are listed in Table 2 on page 16.
Close the door and ensure that no items are caught in the door.
(b)
Selecting a program
Turn the
Program
dial to select the desired drying program. The
Start/Pause
light
starts flashing. If you do not press any buttons within the next 10 minutes, the
program selection will switch off.
(c)
Selecting a program option
Depending on the program, you can add one of the speciality functions to
customise your drying program.
To select a program option, press the relevant option button (
Dry Level, Anti-
Crease, Delay Start
)
after
choosing the desired program and
before
depressing
the
Start/Pause
button. The corresponding indicator light comes on; it will
extinguish when you press the button again.
(d) Start
ing a program
Press the
Start/Pause
button to commence drying. The drum will start rotating.
(e) Pausing
a program
To pause the drying process, press the
Start/Pause
button or open the door while
the program is running. When the machine is suspended, the
Program
dial and
buttons are invalid except for the
Start/Pause
,
Anti-Crease
and
Mute Buzzer
buttons.
To restart the program, press the
Start/Pause
button once again.
(f)
Modifying a program
To change a program which is running, first cancel it by turning the
Program
dial
to the Off position
.
Then select the new program and then press the
Start/Pause
button.
(g)
Cancelling a program
To cancel a program which is running, turn the
Program
dial to the Off position.
IMPORTANT:
If the drying program has to be stopped before it reaches the end,
we recommend you turn the
Program
dial to the “Refresh” position and wait until
the end of the cooling phase before removing the laundry. This will avoid a build-up
of heat inside the appliance. To do this, first turn the dial to the Off position, then to
“Refresh” and then press the
Start/Pause
button.
