Hoover HF7150MUK, Руководство по обслуживанию

Страница: 14 / 17

2003 Range Washing Machines
©
2003 GIAS U.K. / Hoover Ltd.
PAGE 3
DOOR GASKET REMOVAL
•
To remove the gasket assy firstly remove the plastic clamp band around the front of the
gasket. To remove the inner clamp band a 7mm. nut spinner and 7mm. open ended
spanner will be required. Re-fit gasket in reverse order taking care to ensure that the cut
out on the side of the gasket lines up with the hose assy (where used) situated at
approx. 9’o’ clock.
DOOR INTERLOCK TYPES and REMOVAL
A new BI- metal type interlock is fitted on all new 2002 models.
•
To gain access to the interlock remove the clamp band surrounding the tub shell gasket
and ease the front of the gasket off the shell.
•
Remove the two screws holding the interlock and it can be removed from the door
aperture.
•
After servicing the door interlock make sure that the clamp band is replaced .
MOTOR ASSY
•
There are three types of motor fitted to this range of machines , CESET,SOLE and the
HOOVER MOTOR .
•
Where the HOOVER motor is fitted all component parts will be made available, as
shown in the main parts listings.
MOTOR ASSY REMOVAL
• To remove the motor firstly remove the non-adjustable elasticated belt, the motor can
then be removed by undoing the two 10m.m. self tapping bolts.
• Care must be taken when removing and refitting the motor.
•
To prevent damage to the motor supports, place a block of wood at the rear of the
motor under the tacho assembly and tap the motor to gently ease it away from the
mountings.
DRUM AND TUB REMOVAL
•
Remove the Worktop.
•
Open the door and undo the two screws holding the door & the hinge, lift away the door
assembly including the hinge.
•
Remove the gasket clamp band ,release the gasket from the shell and push it through
into the cabinet.
•
Remove the top weight assy, two 10mm. and one 13mm. securing bolts from tub assy.
•
Remove timer assy and associated wiring, motor assy, thermostat, heater connections,
earth connection for drum bearing, sump hose and pecker assy.
•
Carefully lay the machine on its right hand side (timer side) taking care to ensure that
the shell assy interior is protected with some hardboard.
•
Remove the four 7mm. machined screws from the base of each suspension strut.
•
The tub assy is now free to be carefully removed from the shell.
• Access to the lower tub weight is now available and is held in place by three 10mm.
bolts.
•
The drum can now be accessed by removing 16 screws from the tub front,
•
The tub front can be lifted away with the tub shell gasket attached.