Hoover HF7150MUK, Руководство по обслуживанию

Страница: 13 / 17

2003 Range Washing Machines
©
2003 GIAS U.K. / Hoover Ltd.
PAGE 2
Fitting Notes
WORKTOP REMOVAL
• The worktop is of a new design and features a removable rear support allowing access
to the machine by sliding the hardboard top off.
• The rear support is removed by undoing the three 7mm. screws, this will then allow the
worktop surface to be removed by sliding it to the rear.
•
The side supports can then be removed by sliding to the rear.
BEZEL REMOVAL
•
To remove the bezel, firstly remove the worktop side supports, allowing access to the
two screws holding the bezel in position.
•
Remove the two screws.
•
The bezel will then need to be eased up and pulled out of its seating.
TIMER (ROTARY SELECTOR) AND CONTROL KNOB REMOVAL
•
Once the bezel is removed, pull off the control knob and this will then reveal the timer
actuating cam, remove the 8 mm nut, remove the cam assy.
•
Access can then be gained to the 2 x Phillips head screws securing timer to inner bezel
support. Remove the two screws and take the timer off the bezel.
POWER MODULE REMOVAL
•••• This is situated on the top right hand side of the machine between the rotary selector
and the shell. Remove the two screws holding the module container to the top of shell, lift
out from the shell , unclip the module cover and undo the securing screws to remove the
module.
OPTION SWITCH REMOVAL
•
The option switch support assy can be removed by undoing the 5 screws attaching it to
the bezel.
•
Remove the buttons from the switch being replaced.
•
The switch can then be pushed through the support.
PRESSURE SWITCH REMOVAL
•
The pressure switch is secured by a bracket attached to the inner metal support
underneath the timer and can be removed by a single screw attached to the bracket.
SOAP DISPENSER REMOVAL / SETUP
•
The soap dispenser is serviceable and contains three compartments, the third
compartment being available to incorporate the use of fabric conditioner.
•
To remove the dispenser, remove the worktop and bezel disconnect all hoses,
disconnect dispenser actuating arm from the top of the dispenser noting the setting of
the arrow on top of dispenser, remove the single phillips head screw from the top front
of bezel, the dispenser can then be removed complete.
TO SETUP DISPENSER ACTUATING ARM,
Program 1 pointer at 1
st
notch Program 2 pointer at 2
nd
notch
Program 5 Pointer at 3
rd
notch Program 6 pointer at 4
th
notch