4
Step 1 Assemble handle
Attaching dirt cup
assembly
Remove cardboard protector from
bottom of dirt cup assembly.
Attaching upper handle
Slide upper handle onto assembly,
as shown, until the handle snaps
into position.
Make sure dirt cup latch (C) is
down.
Insert the two longer screws into
holes in recessed area above dir t
cup latch (C).
Tighten the screws.
Slide edge of tool rack down into the
channel on the back of the cleaner.
Insert screw into side of tool rack (D).
Tighten screw.
1-2
1-3
1-4
1-5
A
Step 2 Attach tool
rack
1-6
Note:
The
green or white switch
lock
(A) near the ON/OFF switch on
the
back
of the dirt cup assembly,
helps in
assembling
your cleaner.
Assembly can be continued if the
switch lock is missing. However,
do not remove
the switch lock
until assembly is completed.
1-8
1-9
1-7
B
C
D
With dirt cup toward the front,
slide assembly down onto the
extension on cleaner base.
Rock dirt cup assembly side
to side while pushing down
firmly. Extra pushing effort
may be required.
Make sure
assembly is pushed down
completely.
Push bolt into hole (B) on lower
rear of assembly.
If bolt will
not go into hole easily, the
assembly is not pushed
down far enough.
Tighten bolt
securely with a screwdriver.
Step 3 Position tools
Bring hose toward front of cleaner
and stretch hose over hose rack.
Push opposite hose end
firmly
into
rear “cup” in rack.
Note:
Hose end must be firmly con-
nected to tool rack when cleaning
floors.
