STEP 7
STEP 5
STEP 4
RE-ASSEMBLY INSTRUCTION
Step 1: Slide in the wood cap to the lift hardware leg.
Step 2: Put in inside each of side panel, the lift leg with motor will
be on the left side, the other one is on right side.
Attach the lift hardware leg, using provided allen wrench (C) with
flat washer (G), lock washer (F) and bolt (E).
Step 3: Screw the wood to hold the wood cap on front and back side
of side panel on each leg.
Step 4:Attach the tube join support by sliding in tube into legs,
make sure height of the 2 legs are same.
Step 5:Attach the second join support in front of the tube join support
using provided allen wrench (C) with bolt (A).
Step 6:Assembly the join support from below, using provided
allen wrench (C) with bolt (B).
Step 7:Attach the table top, using screw driver
with screws (D)
,
before screwing the top table,place the table top above 2 side panels,
make sure table edges flat
with side panels. Adjust
table height up by
pushing up button until have enough space to screw the table top.
Step 8:Adjust table height by pushing up or down button on right
front side of table top
Step 9: Attach the "U'' bracket (I) using screws (D) with screw driver,
right in the middle of join support bar.
Step 10:Adjust Leveler if needed to level case on uneven floor.
STEP 6
STEP 2
STEP 1
STEP 10
STEP 3
STEP 9
