Honeywell XIO-8AI, Руководство по установке

Страница: 2 / 8

COMPACT I/O MODULE
95-7716—1 2
SAFETY INSTRUCTIONS
NOTES REGARDING DEVICE DESCRIPTION
These instructions include indications for use and mounting of
the device. In case of questions that cannot be answered with
these instructions, please consult the product supplier or
manufacturer. It is the responsibility of the equipment installer
to ensure that all federal, state and local codes are followed.
SAFETY INSTRUCTIONS
• Keep these Installation Instructions for industrial safety and
the prevention of accidents.
• Only qualified personnel shall do mounting and installation
work with these devices, see section titled “Qualified
Personnel”.
• The information in these instructions must be read and
understood by every person using this device.
QUALIFIED PERSONNEL
Qualified personnel in the sense of these instructions are
persons who are well versed in the use and installation of
such devices and whose professional qualification meets the
requirements of their work.
This includes, for example:
• Qualification to connect the device according to applicable
specifications and regulations, and a qualification to put
this device into operation, to power it down, or to activate it
by respecting the internal directions.
• Knowledge of safety rules.
• Knowledge about application and use of the device within
the equipment system.
BEFORE INSTALLATION
1. Unpack the XIO-8AI Universal LON Analog Input
Module.
2. Check the equipment and report any damage to a
Honeywell representative.
3. Read all of these instructions and ensure they are
understood.
MOUNTING
Mount the XIO-8AI Universal LON Analog Input Module on
standard DIN rail per DIN EN 50022 (1.35 x 0.3 in. [35 x
7.5 mm]), in junction boxes and/or on distribution panels.
INSTALLATION
CAUTION
Electrical installation and device termination shall
be accomplished by qualified persons only, by
respecting all applicable specifications and
regulations.
1. Power down the equipment. Mount the module on the
DIN rail.
2. Plug in the terminal block for bus connection.
3. Prepare the cable for bus connection:
a. Remove about 0.75 in. (2 cm) of the plastic cable
sheath.
b. Strip 0.2 in. (5 mm) insulation from each wire. Put a
wire end sleeve to stranded wires.
c. Insert the wire to the respective contact and secure
it by screwing down the contact screw.
d. Wire cross section of the 4 pole terminal block bus/
mains connection:
(1) Maximum 16 AWG (1.5 mm
2
) single wire.
(2) Maximum 18 AWG (1.0 mm
2
) stranded wire.
(3) Wire diameter minimum 28 AWG (0.3 mm) up to
16 AWG (1.4 mm).
1a
M25060
SERVICE
RESET
ON
1b
M25061
SERVICE
ON
RESET
SERVICE 24V 24V
E2
E1
E2
E1
GND
+24V
2a
M25062
RESET
SERVICE
SERVICE 24V
2b
M25063
RESET
ON
SERVICE
24V
24V
E2
E1
GND
+24V
E2
E1
3a
0.2 in.
(5 mm)
M25040
3b
M25064
SERVICE 24V