VISTA-ICM Installation and Setup Guide
8
Figure 6 shows a list of ports on the VISTA-ICM. For each port in the list, perform the
following three steps:
1.
In the column titled
Device
select the Name from the drop-down list that
matches the make and model of the device attached to that port. In some cases
the VISTA-ICM will auto-detect the connected device if it is powered on and
connected. If the device has already been detected, the information in the list
will already reflect the correct device.
Figure 6 - Device Setup - Port Assignment
2.
In the
Device Name
column, enter the name you will use to identify the device.
If you leave the name blank, a default name will be used. It is best to use a
descriptive name that includes the room name if you plan to have more than one
device of the same type.
3.
Click the
Next
button to submit the changes and return to the device selection
page. This will reset any prior configuration information for this VISTA-ICM,
and may require the device to be configured again.
When all the devices in the list have been assigned, click the
Next
button to proceed to
device configuration.