® U.S. Registered Trademark
Copyright © 2000 Honeywell • • All Rights Reserved
INSTALLATION INSTRUCTIONS
69-1387-1
T8024D Programmable
Multistage Thermostat
The T8024 Programmable Multistage Thermostat
provides electronic control of single-zone, multistage
heating and cooling systems. First stage and second
stage cooling cycle rates are fixed at 3 cph. Heating
cycle rate is selectable. Temperature indication can be
set for °F or °C.
The T8024 Thermostat is powered from the system
transformer. Batteries are not required because setpoints
are held permanently by non-volatile memory.
T8024 includes a thermostat, wallplate (for wiring and
mounting thermostat) and owner’s guide.
MERCURY NOTICE
If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of an old control containing
mercury in a sealed tube.
If you have questions, call Honeywell Inc. at
1-800-468-1502.
INSTALLATION
When Installing this Product…
1.
Read these instructions carefully. Failure to follow
them could damage the product or cause a hazard-
ous condition.
2.
Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.
3.
Installer must be a trained, experienced service
technician.
4.
After installation is complete, check out product
operation as provided in these instructions.
CAUTION
Electrical Shock or Equipment Damage
Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
Location
Install the thermostat about 5 ft (1.5m) above the floor in
an area with good air circulation at average temperature.
See Fig. 1. Do not install the thermostat where it can be
affected by:
— drafts or dead spots behind doors and in corners.
— hot or cold air from ducts.
— radiant heat from the sun or appliances.
— concealed pipes and chimneys.
— unheated (uncooled) areas such as an outside wall
behind the thermostat.
This thermostat is a precision instrument and was
carefully adjusted at the factory. Handle it carefully.
Mounting Wallplate to Wall
IMPORTANT
Level only for appearance. The thermostat func-
tions normally even when not level.
Mount wallplate, T8024 and the screws provided (see
Fig. 2) as follows:
1.
Place the wallplate at the desired location on the
wall.
2.
Pull the thermostat wire through the entrance hole
on the decorator cover plate, then through the wall-
plate entrance hole.
3.
Select the two mounting holes that best fit the
application.
4.
Fasten the wallplate to the wall using the anchors
and screws provided.
5.
After wiring the wallplate, plug the hole to prevent
drafts from affecting the thermostat; see Wiring
section.
