4
Quick Installation Guide
8
Disconnect the wires and remove the old wall plate.
Use a screwdriver to release wires from terminals. Then, use a wire label to
identify each wire as it’s disconnected. The letter on the wire label should
match the letter on the terminal.
Tip:
To prevent wires from falling back into the wall, wrap the wires around a
pencil.
Installing your RTH5160 thermostat
9
Bundle and insert wires through the UWP.
Pull open the UWP and insert the bundle of
wires through the back of the UWP.
Make sure at least
1/4 inch
of each wire
is exposed for easy insertion into the wire
terminals.
RTH5160
Thermostat
Screws
UWP
Mounting
System
Anchors
Wall
