Leaflet ref. 8512D9779 Issue 8
1. We wish to inform you that in accordance with Section 6 of the above Act, we take every care, as far
as is reasonably practicable to ensure that our products are safe without risk to health when
properly handled, transported, installed, used, maintained and disposed. However, as manufacturers
and suppliers of a wide range of products, we would advise you that related information for these
products will be found in the following literature.
•
Regulations (such as the COSHH Regulations, Manual Lifting Regulations, Personal Protective
Equipment Regulations), British Standards and other applicable ISO and European
Specifications and Codes of Practice, as applicable to the intended application of the
products.
•
Regulations for electrical equipment of buildings (published by the Institution of Electrical
Engineers).
•
Catalogues and product leaflets of this Company or literature which may be obtained by
specific request to the Company.
2. It is important that the products concerned should be installed, handled, transported,
commissioned and maintained by, or under the supervision of, competent persons in accordance
with good engineering practice and:
•
IEE Regulations for the electrical equipment of buildings.
•
Regulations, British, European, ISO and other standards, specifications and Codes of Practice,
as applicable to the intended application of products, i.e. Water Supply Bye-Laws.
•
Statutory Requirements.
•
Any instructions specifically advised by the Company and, where appropriate, with particular
reference to information marked on the product. The product must only be used in the
condition supplied or specified by the Company, without modification, and for the purpose for
which it was designed.
3. In accordance with your statutory duties to employees and other persons, you are therefore
requested to take such steps as are necessary to ensure that any appropriate information relevant
to our products is made available by you to everyone concerned. The Company takes no
responsibility for any failure to comply with the above guidelines.
Health and Safety at Work Act 1974
Elster Water Metering Limited
130 Camford Way
Sundon Park Luton
Bedfordshire LU3 3AN
United Kingdom
T: +44 (0)1582 846400
F: +44 (0)1582 564728
[email protected]
www.elstermetering.com
The Company’s policy is one of continuous improvement and the
right is reserved to modify the specifications without notice.
DECLARATION OF CONFORMITY
This declaration of conformity is issued under the sole
responsibility of the manufacturer, Elster Water Metering
Limited, 130 Camford Way, Sundon Park, Luton,
Bedfordshire, LU3 3AN UK
We hereby declare that the meter type:
Q4000
Conforms with the essential requirements of:
Directive 2014/32/EU and, where applicable, with the
essential requirements of: Directive 2014/30/EU and
2014/53/EU
Our Notified Body for the purpose of Module D
of 2014/32/EU is NSAI 0050
Signature:
…………………………………………
Full Name:
Nigel Maynard
Position:
Quality Manager
Date:
Aug 2019
