System Installation Guide
26
69-2490—03
Replacing system components
To replace an Equipment Interface Module (EIM) or thermostat
Follow steps below to
disconnect
the thermostat and RedLINK accessories. See
pages 5-6 to re-link
devices.
At the thermostat
(skip this step if no EIM is used)
1 Press
MENU > INSTALLER OPTIONS
, then enter date code when prompted
(printed on back of thermostat). Or press
MENU > EQUIPMENT STATUS
to find
the date code.
2
Scroll down to select
WIRELESS DEVICE MANAGER
.
3
Press
REMOVE DEVICE
, then click
THIS THERMOSTAT
to remove.
At the Portable Comfort Control
1 Press and hold the blank space (or arrow if
present) in the lower right-hand corner of the
screen until the display changes.
2 Press
REMOVE
, then
YES
to disconnect from the
old EIM or thermostat.
At the Indoor Sensor, Wireless Remote, RedLINK Internet Gateway, or
TrueSTEAM Wireless Adapter
Press and hold
the
CONNECT
button on the RedLINK accessory until the status
light glows amber (hold for about 10 seconds). This will disconnect the device
from the old EIM or thermostat.
To remove accessories from an EIM or thermostat
At the thermostat
1 Press
MENU > INSTALLER OPTIONS
, then enter date code when prompted
(printed on back of thermostat). Or press
MENU > EQUIPMENT STATUS
to find
the date code.
2
Scroll down to select
WIRELESS DEVICE MANAGER
.
3
Press
REMOVE DEVICE
, then select the device you want to remove.
At the Equipment Interface Module
Press and hold
the
CONNECT
button on the EIM until the status light glows amber
(hold for about 10 seconds). This will disconnect ALL devices from the Equipment
Interface Module.
MCR32958
Press and hold
in lower right
corner of screen
If the THX9321 thermostat is setup without an EIM, all thermostat settings must be reset before it can be used with an EIM.
Press
MENU > INSTALLER OPTIONS
, scroll down to select
ADVANCED OPTIONS
, then press
RESTORE FACTORY
DEFAULTS
.
69-2490_B.indd 26
7/13/2011 1:42:02 PM
