NPB-ZWAVE OPTION CARD
3
62-0349-01
6.
Carefully insert the pins of the NPB-ZWAVE into the
socket of the appropriate option card slot. Mounting
holes on the option board should line up with the stand-
offs on the base board. If they do not, the connector is
not properly aligned. Press until the option card is com-
pletely seated.
Figure 3 shows a card going into
Slot 2
of WEB/CP-201/600
series controller.
Fig. 3. Option card going into Slot 2
7.
If a WEB/CP-201/600 series
, set the battery and
bracket assembly back over the option card slots, with
the mounting holes aligned with the standoffs.
8.
Place the four screws through the battery bracket, end
plates, and into the standoffs on the controller base
board. Hand tighten these screws.
Fig. 4. Re-fasten screws through battery bracket
9.
Plug the battery cable into the battery connector on the
controller see Figure 4.
10.
Replace the controller’s cover.
If accessory modules were unplugged, plug them back
into the controller as before, and secure.
ATTACHING ANTENNA
A
stub antenna with RP-SMA coax connector is provided for
use with a WEB/CP-201/600 or WEB/CP-700 controller. To
attach, simply insert into the coax jack on the option card, and
finger-tighten the knurled nut (See Figure 5).
Fig. 5. RP-SMA stub antenna on WEB/CP-201/600
Rotate in whatever position is needed for mounting clearance
and/or best reception. If needed, you can use the antenna
extension option.
ANTENNA EXTENSION OPTION
To locate the included stub antenna off the controller, or if
installing in a WEB/CP-202/602-XPR model, order and install
the H-CBL-SED-EXT option. Included is a 6.56 ft. (2m)
RP-SMA-type coax extension cable and steel bracket for wall
or panel mounting. See Figure 6 for details and dimensions.
Fig. 6. Dimensions in in. (mm)
M32455
INSERT OPTION CARD
INTO OPTION CARD
SLOT CAREFULLY,
WITH
PINS ALIGNED
.
FULLY SEATED CARD
M32456
HAND TIGHTEN 4 SCREWS
THROUGH BATTERY BRACKET, END
PLATES, INTO STANDOFFS.
CONTROLLER
BATTERY
CONNECTOR
M32457
STUB ANTENNA
INSTALLED ON
NPB-ZWAVE
OPTION CARD
.236
(6)
(15.9)
.625
.251
1.25
(6.37)
2.0
(50.8)
(31.8)
1.13
(28.7)
.625
(15.9)
STUB ANTENNA
BRACKET
RP-SMA
TYPE COAX
EXTENSION
CABLE
MOUNTING HOLES (2)
.170
(4.32)
1
(25.4)
M32458
