NPB-ZWAVE OPTION CARD
62-0349-01
2
MOUNTING
WARNING
Power to the controller must be OFF when
installing or removing option cards, or damage
will occur! Also, you must be very careful to plug
any option card into its connector properly (pins
aligned).
Mount the NPB-ZWAVE option card in either of the option
card slots of the controller, as needed. Note the WEB/CP-202/
602-XPR series has only one option card slot.
Mounting NPB-ZWAVE option card.
1.
Remove power
from the WEB/CP Controller—see
the previous Warning.
2.
Remove the JACE cover
or covers (WEB/CP-202/
602-XPR)
.
For all but the WEB/CP-202/602-XPR, press in the
four tabs on both ends of the unit, and lift the cover
off.
If a WEB/CP-202/602-XPR, first remove the right
cover, then the left cover, retaining the two screws that
secure each cover.
NOTE: If accessory modules are plugged into the controller,
you may need to slide them away from the unit to get
to the cover tabs.
3.
If a WEB/CP-202/602-XPR series, remove the bat-
tery and bracket assembly by taking out the
screws holding it in place, setting screws aside for
later.
Figure 2 shows an exploded view of a WEB/CP-600.
Fig. 2. Remove screws and battery assembly
NOTE: The tie wrap on the battery pack should have its lock
“knot” on
top
, as shown in Figure 2.
If not, cut and
remove
the tie, then
re-install
another
tie wrap with its lock tab on top.
(
Tie lock at bottom interferes with option card
).
4.
If a WEB/CP-201/600-XPR or
WEB/CP-700
,
remove the option slot blanking plate, retaining the
two screws.
NOTE: Slot 2 option card installation in a
WEB/CP-700
controller requires careful attention! See its
Mounting
and Wiring Guide
for more details. This document
focuses on installation in a WEB/CP-201/600 series
controller.
5.
Remove the blanking end plate for the slot you are
installing the option card into.
(Retain the blanking end plate in case the option card
must be removed at a later date.)
M32454
SCREWS (4)
UNPLUG BATTERY HERE
OPTION
SLOT 2
AREA
WEB/CP-600
OPTION
SLOT 1
AREA
BLANKING END PLATE
TIE WRAP
LOCK
(SEE NOTE)
BATTERY ASSEMBLY
(INCLUDES
CABLE AND
BRACKET)
