- 17 -
Scan Menu 01/08
Scan 01 : AUTOSCAN01
Speed : 1~8
Start : 127.1, 027.0 zoom
End : 157.7, 080.7 zoom
Dir : CCW (PAN:000.0)
Swap : OFF
Save And Exit
Follow the steps below to program Scans.
1.Press the
SCAN
key to enter Auto Scan menu directly.
(
or
MENU
=>
Function
=>
Scan
)
.
2.Select the Scan number by pushing the
Joystick
left or right.
3.Twist the
Joystick
to enter the title by scrolling through the alphanumeric characters and
pushing the handle to the right or left to move to the next space. Press
ENTR
key or push the
Joystick
down to finish title mode.
4.Push the
Joystick
downward to select “SPEED” and set the speed by twisting the
Joystick
clockwise or counterclockwise or moving the
Joystick
left/ right to select the auto scan speed.
5.When finish entering the title, Select “START” with the
Joystick
to the left or right and select the
start position. Current panning position will be displayed. To complete the selection of the start
position hit the Focus button to stop.
(Or twist zoom handle or hit zoom button to start PTZ control
for view selection and hit the Focus button to stop.)
6. Move the Joystick downward to select “END”. Move the Joystick to select the end position. To
complete the selection of the end position hit the Focus button to stop.
7.Move the
Joystick
downward to select “DIR(Direction)” Set the scan direction by moving the
Joystick
left and right to select the auto scan direction.(CW or CCW)
8. Move the Joystick downward to select “
SWAP
” and set the swap by moving the Joystick
left and right to select the swap ON or OFF.
9. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the program
without saving.
Note : Pressing the
HOME
or
OFF
Button to delete stored data,
SCAN01
: AUTOSCAN01 ~ SCAN08: AUTOSCAN08
SPEED(MODE
) : 1/ 2 / 3/ 4/ 5/ 6/ 7/ 8
1: SLOWER ↔ 8 FASTER
The Scan function supports up to 8 programmed section of angles at 8 programmable speeds
.
Program and Operation
1.3 SCAN (
MENU
=>Function =>
Scan
; Short cut :
SCAN
)
ENG
