Installation Guide
P/N 041-338 Rev. A
12 69-2655EFS—01
Adding the thermostat to a Lutron system
Programming by a Lutron Factory Trained Installer
For full functionality, the HVAC Controller must be programmed to a Repeater and PC software
must be used by a Lutron factory-trained installer. For questions on how to become a qualified
installer, please contact your local Lutron representative.
To add the thermostat to a Lutron system:
Use the Lutron PC software to start activation
mode. When a Lutron system is in activation mode,
an unaddressed thermostat will show “Device Is
Unaddressed” at the top of the screen.
1. To activate thermostat press
MORE
.
The thermostat will now show the connection screen
and display “Press Connect” at the top of the screen.
2. Press the
CONNECT
button. The
CONNECT
button will
blink and the thermostat will display “Addressing”
at the top of the screen.
3. Return to the Lutron software and confirm
thermostat activation. When activated, the
thermostat will exit the connect screen and
display “Device Is Addressed” at the top of the
screen.
4. The thermostat is now activated.
Note: The More button will disappear once the
thermostat is addressed to a Lutron system.
Note: Use ISU setting 900 to remove the thermostat
from the Lutron system. See page 10.
M33049
MORE
PM
M33050
CONNECT
NO SIGNAL
EXIT
M33051
PM