Honeywell JOSI-DBC012-N11, Руководство по установке

Страница: 19 / 40

ACUIX
TM
Fixed Dome User Guide
Document 800-01605 Rev A 19
04/08
Figure 1-5 Spacing Wing Tabs
b. Position the wing tabs flat against the housing. Insert the housing through the
hole in the ceiling (some jostling is required). Using a Phillips screwdriver, turn
the two screws in the housing clockwise to rotate the tabs out and tighten the
tabs against the ceiling. The recommended maximum torque is 1–1.25 N-m
(Newton meters) or 0.74–0.92 lbf-ft (pound-force-foot) or 8.85–11.06 lbf-in
(pound-force-inch).
6. Refer to Connecting the Cables on page 20 for information on connecting the field
wiring to the interface board in the housing.
7. See Installing the Camera Assembly on page 21 for information on installing the
camera assembly and Installing the Lower Dome on page 23 for information on
installing the lower dome.
Indoor Pendant Housing Installation
WARNING! Installation must be performed by qualified technical
personnel and must be in accordance with all national and
local mechanical and electrical codes.
Perform the following steps to install an ACUIX™pendant housing on a Honeywell Video
Systems indoor wall dome mount or ceiling dome mount. See
Figure 1-6 .
1. Select the location of the housing. Each ACUIX™ Fixed requires either a 17 to 28
VAC or an 11 to 16 VDC power source measured at the housing. Each ACUIX™
Fixed has a power consumption of 3.5W for the color cameras or 4.5W for the WDR
cameras. Ensure a 24 VAC/12 VDC @ 0.2A power source is available. See
Appendix B, Cable Guidelines on page 35 for maximum wiring distances to the
dome.
2. Install the mount using the instructions provided with your specific mount.
3. Run the field wiring (control data, video, power, and alarm) through the mount. The
wiring must extend at least one foot (0.3 m) past the pipe for wiring purposes. See
Cable Guidelines on page 35 for detailed wiring information.
4. Locate the pendant housing.