4
HP400ULM Installation Document P/N 52390:A 1/05/06
5 Battery Stand-By Mode Specification Chart
6 Maintenance
This unit should be tested at least once a year to verify correct operation in accordance with the following
recommendations;
Output Voltage Test -
Voltage output should be tested under normal load conditions to verify correct levels.
Battery Test -
Battery should be checked for full charge under normal load conditions. This check should verify correct
voltage at both battery terminals and also at the Battery output point on the board to ensure the integrity of all connecting
wiring. It is recommended to replace the battery at least every 4 years.
LED Test
(distribution board only)
-
Verify yellow LED operation by pushing LED test button. All yellow LED’s should
illuminate.
Output Battery
Capacity
STBY/ALRM
4Hr Stand-By
15Mins/ALRM
24Hr Stand-By
15Mins/ALRM
60Hr Stand-By
5Mins/ALRM
12Ah-12V
STBY
2.00A
N/A
N/A
ALRM
3.50A
N/A
N/A
17Ah-12V
STBY
2.00A
200mA
N/A
ALRM
3.50A
2.00A
N/A
55Ah-12V
STBY
3.50A
1.50A
300mA
ALRM
3.50A
3.50A
3.50A
12Ah-24V
STBY
2.00A
N/A
N/A
ALRM
3.50A
N/A
N/A
17Ah-24V
STBY
2.00A
200mA
N/A
ALRM
3.50A
3.50A
N/A
55Ah-24V
STBY
3.50A
1.50A
300mA
ALRM
3.50A
3.50A
3.50A
UL Listing
UL294
UL603
UL294
UL603
UL1481
UL1481
!
WARNING: To reduce risk of electric shock, do not expose unit to rain or excess moisture, and disconnect
power before servicing unit.
For continuous protection against hazard, replace fuses only with exact type and rating. A readily accessible
switched circuit breaker must be available to disconnect main power as required. All power limited wiring should
be routed so that it cannot touch non-power limited wiring; minimum spacing 1/4”. Installation and servicing
should only be made by qualified personnel; contains no user-serviceable parts. Install in accordance with all local
regulations and the National Electrical Code.
Continued on next page...
