Honeywell HDZ30A, Руководство пользователя

Страница: 78 / 114

www.honeywell.com/security
78 | HDZ Series Analogue PTZ User Manual
Configuring the Alarm Output
There are two alarm outputs for the HDZ Series Camera. Users can set 1 , 2 , 1+2 or OFF to
trigger the alarm output devices (such as a siren or flashing light) when the alarm is triggered.
Exiting the Alarm Setting Menu
Exit the ALARM SETTING menu and go back to the MAIN PAGE 3 to carry on setup of other
relevant camera options.
Setting the Motion Detect Function
When the Motion Detect function is activated (see Figure 4-26 ), the camera will detect
movement within a monitoring area and then automatically send an alarm signal if movement is
detected. There will be a flashing warning notice,
MOTION
, displayed in the upper left corner of
the screen.
Figure 4-26 Alarm Detect Menu
Setting the Detect Switch
Select ON or OFF in this field to enable or disable the MOTION DETECT function.
Setting the Detect Mode
MOTION is the only detect mode available to select with your HDZ Series Analogue camera.
Motion Detection function allow detecting suspicious motion and triggering alarms when motion
volume in the detected area reaches/exceeds the determined sensitivity threshold value. See
Figure 4-26 for the fields of the Alarm Detect menu.
Setting the Block Mode
In Motion Detect mode, users can set Block Mode as ON or OFF . When BLOCK MODE is
turned on, if there are any variations (caused by intrusion, for example) in the sections of the
monitoring image, the affected parts will be dynamically highlighted.
ALARM DETECT
DETECT SWITCH OFF →
DETECT MODE MOTION
BLOCK MODE OFF →
FRAME SET 01 ↓→
FRAME DISABLE 01 ↓→
THRESHOLD 016 →
EXIT YES