Honeywell HD54IP, Руководство пользователя

Страница: 26 / 84

26
Installation and Setup
Step 8. Sealing the Wiring
To prevent moisture from entering the housing, you should apply the appropriate sealant
around the conduit entry and mounting screws.
Step 9. Adjusting the Camera
Connecting to a Video Monitor
The local video out connection (see Figure 2-5 or Figure 2-6 ) is available as a test output
and should be used during installation to position, aim, and focus the camera, as needed.
Connect from the local video out connector on your camera to the video input connector
on your spot monitor.
Adjust the FOV (Field of View)
To adjust the your camera:
1. Verify that power is supplied to the camera.
Note Please wait approximately 60 seconds after connecting to a power source for
video to appear on the local video output.
2. Reinstall the gimbal by inserting the black tabs into the black clips on the enclosure
base.
3. Connect the supplied video cable to the local video out connector to view the video
signal on a standard monitor (see
Figure 2-6 ) for the location of the local video out
connector).
4. Loosen the setscrew that locks the gimbal assembly in place (see Figure 2-6 ) to
adjust the horizontal rotation.
5. Adjust the camera gimbal to the desired view.
6. Re-tighten the locking screw to lock the gimbal assembly in place.
7. Disconnect the video cable from the local video out connector after making all needed
adjustments to the camera (see also
Adjusting the Lens Focus on page 27 ).
Note Figure 2-6 illustrates the ways in which you can adjust your camera.