800-10344 12/11 Rev. A
GSMVLP5-4G/GSMVLP5CN4G
GSM and ILP5 Ethernet
Communications Modules
Installation and Setup Guide
Installing Communication Modules
Installing the GSMVLP5-4G/GSMVLP5CN4G in the LYNX Touch Series Control
Ensure that SIM card and the connector board are securely installed in the GSMVLP5-4G/GSMVLP5CN4G
before installing the module in the LYNX Touch.
1. Install the provided FCC/IC label (P/N 800-10341) on the control’s case back (refer to Figure 1).
5000-100-186-V1
800-10341 Label
800-10259 11/11 Rev A
FCC / IC STATEMENT
IC: 573F-LYNXTOUCH2
This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the
following two conditions: (1) This Device may not cause harmful interference. (2) This device must
accept any interference received, including interference that may cause undesired operation.
IC MODEL: LYNXTOUCH2
FCC ID: CFS8DLLYNXTOUCH2
CONTAINS MODULE: FCC ID: QIPPH8 IC: 7830A-PH8 IC MODEL: PH8
Figure 1. FCC/IC Label Location
2. Release the LYNX Touch front case from the back case by depressing the two locking tabs at the top of the
unit with the blade of a medium size screwdriver (Refer to Figure 2).
3. Install the GSMVLP5-4G/GSMVLP5CN-4G into the LYNX Touch control front case. Ensure that the
connector board is properly seated into the receptacle on the control (Refer to Figure 2).
4. Secure the GSMVLP5-4G/GSMVLP5CN-4G with the three provided screws (Refer to Figure 2).
5. Enable the GSMVLP5-4G/GSMVLP5CN-4G device, configure alarm reporting and module supervision and
register the device. Refer to the “Program the Radio” and “Diagnostics” sections in the LYNX Touch Series
Installation and Setup Guide (P/N 800-10614 or higher).
For Documentation and Online Support:
http://www.security.honeywell.com/hsc/resources/MyWebTech