4 - 22
When the output sequence is
Off
, the bar code data is output to the host as the scanner decodes it.
Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Multiple Symbols
When this programming selection is turned
On
, it allows you to read multiple symbols with a single pull of the scanner’s trigger.
If you press and hold the trigger, aiming the scanner at a series of symbols, it reads unique symbols once, beeping (if turned on)
for each read. If using a Granit scanner, the scanner also vibrates. The scanner attempts to find and decode new symbols as
long as the trigger is pulled. When this programming selection is turned
Off
, the scanner will only read the symbol closest to the
aiming beam.
Default = Off.
No Read
With No Read turned
On
, the scanner notifies you if a code cannot be read. If using an EZConfig-Scanning Tool Scan Data
Window (see page
), an “NR” appears when a code cannot be read. If No Read is turned
Off
, the “NR” will not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you can edit the output message (see
beginning on page 6-1). The hex code for the No Read symbol is 9C.
Required
On/Not Required
*Off
On
* Off
On
* Off
Содержание Granit 1911i
