Honeywell Genesis 7580G, Руководство пользователя

Страница: 52 / 202

3 - 10
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read bar codes from mobile phone or other LED displays. However,
the speed of scanning printed bar codes may be slightly lower when this mode is enabled. You can enable Mobile Phone Read-
ing for either a hand held device or for a hands-free (presentation) application. When in
Streaming Presentation – Mobile
Phone mode the illumination LEDs remain on and the decoder remains on. When in Presentation – Mobile Phone mode the
illumination LEDs remain off until a bar code is presented to the scanner, then the aimer and the LEDs turn on to read the code.
Note: To turn off Mobile Phone Read Mode, scan the Presentation Mode bar code (see page 3-6 ).
Hands Free Time-Out
Presentation Modes are referred to as “hands free” modes. If the scanner’s trigger is pulled when using a hands free mode, the
scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trigger mode by setting
the Hands Free Time-Out. Once the time-out value is reached, (if there have been no further trigger pulls) the scanner reverts
to the original hands free mode.
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save . Default = 5,000 ms.
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a
Presentation Mode (see page
3-6). Default = Medium.
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
Presentation - Mobile Phone
Hands Free Time-Out
Short (500 ms)
* Medium (750 ms)