F300-19-00
4
I56-1875-006
©2008 Fire•Lite Alarms, Inc.
This device complies with part 15 of the FCC Rules. Operation is subject to the fol
-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential instal
-
lation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer
-
NOTES:
The relay contacts on the CRF-300-6 may be connected to either a
•
power-limited or non power-limited source, this wiring must remain
separated by at least 1/4˝ (6.35 mm) from all power-limited wiring.
Power-limited circuits must employ type FPL, FPLR, or FPLP cable as
•
required by Article 760 of the NEC.
For easier wiring, assign all power-limited wiring to one side rather than
•
alternating with non power-limited.
PROGRAMMING
The CRF-300-6 module operates with the following Fire Alarm Control Panels:
MS-9200
•
MS-9600
•
0
1
2
3
4
5 6
7 8 9
0
7 8
6
5
4
3
2
1
9
10
11
12
13
14
15
N.C.
N.O.
COMMON
ADDRESS 5
N.C.
N.O.
COMMON
ADDRESS 4
N.C.
N.O.
COMMON
ADDRESS 3
N.C.
N.O.
COMMON
ADDRESS 2
N.C.
N.O.
COMMON
ADDRESS 1
N.C.
N.O.
COMMON
ADDRESS 0
– +
– +
SLC
BASE ADDRESS
ADDRESS
DISABLE
NONE
ONE
TWO
THREE
6.8"
5.8"
FROM PANEL
OR PREVIOUS DEVICE
SIGNAL LINE CIRCUIT
32 VDC MAX.
TWISTED PAIR IS RECOMMENDED
TO NEXT
DEVICE
–
+
–
+
–
+
NC
NO
COMMON
RELAY CONNECTIONS
STATUS
INDICATORS
FIGURE 7. WIRING ANd PROGRAMMING ThE CRF-300-6 MOdULE:
C0778-02
FCC STATEMENT
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
firealarmresources.com