F114 AND F115 CEILING SURFACE MOUNTED MEDIA AIR CLEANERS
5
68-0201-2 Revised 11-07
IMPORTANT
When installing the air cleaner, be sure to follow all
local codes and accepted practices.
1.
Decide if the air cleaner wire connections will be from
from the top or the side. Make the necessary wiring
provisions at the ceiling.
2.
Grasp the air cleaner cover edge near the plenum
and remove the cover from the support brackets.
Set it aside.
3.
Loosen and remove the filter securing nuts, holding
plates and filters. Set them aside.
4.
Insert fastening hardware (lag bolts, eye bolts or
threaded rod) through the 3/8 in. (10 mm) mounting
holes in the filter/motor bases. See Fig. 1 or 2.
5.
Secure the air cleaner to the ceiling load bearing
supports or joists. If installing on a T-grid drop ceiling,
secure the air cleaner to the true ceiling.
6.
Fasten the plenum assembly snugly against the ceiling.
IMPORTANT
Do not over-tighten the plenum fasteners which can
collapse or break the plastic base/plenum.
7.
Connect the power. See Fig. 4 and 5.
MOTOR
MOTOR
JUNCTION BOX
CONDUIT IN
PLENUM
M11693
BLACK
BLACK
BLACK
RED
RED
GREEN
WHITE
WHITE
GREEN
WHITE
Fig. 4. F114 Media Air Cleaner (120, 60 Hz) typical wiring
diagram.
Fig. 5. F115 Media Air Cleaner (120, 60 Hz) typical wiring
diagram.
IMPORTANT
Make sure the air cleaner is grounded for proper
operation and safety.
8.
Turn on the power and check that the blowers are
operating freely.
9.
Position the filter cartridges on the filter base.
10.
Insert the CPZ™ cartridge with the cartridge base
notches against the motor towers.
11.
Attach the filter cover plates.
12.
Replace the air cleaner cover.
OPERATION
The F114 and F115 Ceiling Surface Mounted Media Air
Cleaners provide their own air circulation. When the air
cleaner is powered, the blower/motor draws the
contaminated air into the air cleaner. Particles that are too
small to be caught in the prefilter are removed by the particle
or HEPA filter. The cleaned air is then returned to the building
space.
In areas with ceilings up to 10 feet high, the F114 models can
effectively clean an area of 200 to 600 sq ft (18 to 54 sq m).
The F115 models can clean a 600 to 1200 sq ft (54 to 108 sq
m) area.
SERVICE
The air cleaner removes a variety of particulate contaminants
from the air. In the process of cleaning the air, the air cleaner
filters become dirty.
To maintain a high standard of reliability and efficiency, it is
necessary to periodically service the air cleaner. The filter life
is determined by the quantity and type of contaminants
present and the frequency of air cleaner use. In relatively
clean spaces, the filter life can extend as long as 30 months.
In areas that are very smoky and dusty, filters need to be
replaced sooner. The frequency of servicing can only be
established after a period of use.
NOTE:
Some Full-Service Distributors provide regular
servicing to commercial establishments.
MOTOR
MOTOR
MOTOR
MOTOR
WHITE (N)
BLACK (L1)
GREEN/YELLOW
JUNCTION BOX
CONDUIT IN PLENUM
M12736
WHITE (N)
BLACK (L1)
GREEN/YELLOW
WHITE (N)
WHITE (N)
BLACK (L1)
BLACK (L1)
GREEN/YELLOW
GREEN/YELLOW