Honeywell Enraf 854 ATG, Руководство по установке, Страница: 2 / 24

Preface
Page 2 Installation guide 854 ATG
Preface
The Honeywell Enraf 854 ATG is a servo gauge which measures the liquid level and can also be
programmed to measure two additional interface levels.
This installation guide is intended for technicians involved in the mechanical and electrical
installation of the Honeywell Enraf Series 854 ATG (Advanced Technology Gauge).
EC declaration of conformity
Refer to the EC declaration of conformity, shipped with the instrument.
Note:
All connections to the instrument must be made with shielded cables with exception of the
mains, alarm outputs and Honeywell Enraf field bus cable. The shielding must be grounded in
the cable gland on both ends of the cable.
Legal aspects
The mechanical and electrical installation shall only be carried out by trained personnel with
knowledge of the requirements for installation of explosion-proof equipment in hazardous areas.
The information in this installation guide is the copyright property of Enraf B.V., Netherlands.
Enraf B.V. disclaims any responsibility for personal injury or damage to equipment caused by:
$
Deviation from any of the prescribed procedures;
$ Execution of activities that are not prescribed;
$
Neglect of the general safety precautions for handling tools, use of electricity and
microwave radiation.
The contents, descriptions and specifications in this installation guide are subject to change without
notice. Enraf B.V. accepts no responsibility for any errors that may appear in this installation guide.
Additional information
Do not hesitate to contact Honeywell Enraf or its representative if you require additional
information.