Additional Connectors
Tamper
GND
Audio dev.
power
J6
Audio
Spare
CMD
Audio
J7
J10
J11
Equip
+ 12V max
(
150 mA max
)
Output
J8
GND
Zero crossing
GND
J9
X10
Rx
Tx
The pr
esence of connectors depends on version
J11
J10
Wiring Map
Internal audio
External audio
The CMI800 control panel contains connectors*, allowing for:
An output device (J8). This device should be powered by an external
source (12V max).
An external tamper (J6).
Up to three remote audio modules type TP800 (J6 and J7). Total
cable length between the audio modules and the control panel
shouldn’t exceed 33m. The audio module power supply on
connector J6 should be used exclusively for the connection of a
TP800 using a telephone cable. The use of the integrated local audio
module and/or the remote audio module is selected using jumper J10
(see diagram).
An XM10 transmitter (J9) to pilot X10 receivers with an X10
address and On/Off states. Check cabling details with the XM10
device manufacturer.
The XM10 transmitter uses a telephone cable to connect to the
panel.
If the J10 connector is supplied with only 1 jumper, the external
audio is active by default and only requires connection of the audio
module (see diagram on left).
J3
LEDs
If you are not using the TCU keypad for programming, a serial port
(J3) is available to connect a PC or PDA, with an optional cord, via
an RJ45 connector. Specific serial cables are sold separately.
* The availability and function of the connectors is dependent upon the product version.
J2
PNV
L1
L2
P1
P2
<<
>>
>
>
Connect the telephone line using the stocko connector (included)
and a 6mm single-wire telephone cable.
Terminals are marked “L1, L2” for Input and “P1, P2” for Output.
The telephone line interface has built-in voltage surge protection
and line failure detection.
WARNING:
The wires must not be stripped when using the Stocko connector.
8
English
Mounting
Содержание Domonial cai
Страница 2: ...2 English ...
Страница 75: ......