Honeywell BENDIX/KING KLN 94, Руководство пилота

Страница: 160 / 284

played on line 3, and the distance will be displayed on line 4.
5. Use the right outer knob to move the cursor over the groundspeed
field on line 5.
6. Select your estimated ground-
speed for the trip. As you
change it, the estimated time en
route (
ETE ) calculation will be
updated (figure 5-64).
To calculate distance, time and ESA for a flight plan:
1. From the AUX 4 page, turn on
the cursor (
B
) and use the
right inner knob to select Fpl (fig-
ure 5-65).
3. Turn the right outer knob clock-
wise to place the cursor over the
flight plan number. As you cycle
through the flight plans by turn-
ing the right inner knob, the first
and last waypoints of each flight
plan will be displayed, along with
the total distance and the mini-
mum en route safe altitude for
the flight plan (figure 5-66).
4. Once you have selected the desired flight plan, move the cursor to the
groundspeed field on line 5.
5. Select your estimated ground-
speed for the trip. As you
change it, the estimated time en
route (
ETE ) calculation will be
updated (figure 5-67).
5.10.2. THE AUXILARY 5 (AUX 5) TRIP PLANNING PAGE
The AUX 5 page is for calculating fuel requirements for the trip selected
on the AUX 4 page. To use this page, you need to have a good idea what
the typical fuel flow rate for your aircraft is. This information can often be
found for given cruise power settings in a “performance” section of the
Pilot’s Operating Handbook for the aircraft. The units for fuel are not speci-
fied on this page, but the units of time are always hours. This means that
you can use gallons per hour, pounds per hour, kilograms per hour, etc.
Like with the AUX 4 page, the fuel calculations can be done from present
position to waypoint, waypoint to waypoint, or for one of your flight plans.
Chapter 5 Intermediate Operation
5-26
Figure 5-64
Figure 5-65
Figure 5-66
Figure 5-67